Description

 By minimising seat width and pitch, the R2195 schoolbus seat enables vehicle builders and operators to maximise forward-facing seating capacity whilst providing every passenger with an integral, 3-point, height-adjustable safety belt.

Features

• Available in two widths (300, 340mm)
• Available as singles, doubles or trebles
• Standard lap/diagonal, height adjustable,
  inertia-reel belt - fully integrated
• Variable leg heights and centres
• Minimised seat pitch measurement
• Suitable for use with various
  quick-release fittings
• Seat belt anchorages meet the
  load requirements for category M3 vehicles
• Textured paint finish

Accessories

• Flexible seat belt buckle
• Folding armrest
• Adjustable headrest

Trim
To match original material in most vehicles. Vinyls and moquettes also available.

Dimensions (for guidance only)

Notes

1 Caution: It is not possible to test every permutation of seat width, accessory combination, leg height, position and type, or seat belt requirement. For this reason, it must be emphasised that compliance cannot be assumed where there is any deviation from the standard supply or assembly method. Additionally, the advantages of this product may be lost if insufficient consideration is given to the method of installation of the seat in the vehicle.
2 FULL compliance to seat belt anchorage regulations can only be achieved through vehicle testing.
3 Product improvement may affect specifications.
4 Tested to reduced loads allowable under DTC regulations. (A copy of the DTC approval available upon request.)